![]() e.g., all blockwork wall hatching is to be placed on a layer blockwork wall hatching. Of Length Ring Spacing Should Be Of 150 mm C/C.ġ2- Development Length Shall Be 50 Times Dia Of Barġ3- Design Is Based On S.B.C Assumed As 150 Kn/M De-shuttering Time periodĤ- Column Sides- 24-48 Hours (As per engineer in charge)įor more know about civil engineering Please visit our YouTube Channel. Note that all hatching and symbols specific to a building entity should be placed on a specific hatch or symbol layer for that entity. Column Ring/Stirrups Should Be At Spacing Of 100 mm C/Cįor Length Of 450 mm Above And Below Joints And For Rest Lap Length For Reinforcement Shall Be 50 Times Dia Of Bar Ifġ1. The Notice Of Consultants/Engineers Before Execution.ġ0. Construction drawings with elaborate notes, detailed dimensions, door/window sizes, exit units, etc. The contractor shall document all as-built information not shown on the approved plans and provide that information to the developer’s engineer for incorporation into the final as-built drawings. Generally, all drawings must be legible and on appropriate size paper (11 by 17), clearly indicating the full scope of work through plans, elevations, and sections. City of Poulsbo Developer’s Guide and Construction Standards and Specifications 2008 Appendix A Standard Drawing Notes 12. If Any Discrepancy Found In The Drawing Shall Be Brought To additional notes or information not listed below be placed on drawings. Size And Location Of All Floor And Roof Curbs.ĩ. Size And Location Of Floor Drains, Slopes, Depressed Areas Etcĭ. Size And Location Of All Interior And Exterior Non bearing Partitions.Ĭ. Size And Location Of All Door And Window Openings.ī. BS 8888 Technical Product Documentation (TPD) Specification for defining, specifying and graphically representing.Notes on Process Drawings: Notes On Mecha. In either case, you would be able to change the content in the. dwg file and put into any drawing as an XREF. txt file, and you could put them into any drawing you want as RTEXT. Should Not Be Less Then 20 N/Sqmm In 28 Days As Per Is : 456-Ĩ- See The Architectural Drawings For Following :Ī. That depends on what you mean by 'standard.' For example, you could have, say, a batch of typical sheet notes in a. Shall Be M:20 (1:1.5:3) Nominal Mix By Volume ForĪll R.C.C Members, Average Compressive Strength Of Concrete work and structure drawing, all structure drawing shall be referred along with architecture drawings.Ģ- All dimension are in inch/ feet unless noted otherwise do not scale the drawing.ģ- Pouring of concrete shall be after checking & satisfaction of site-engineer.Ĥ- Reinforcement (steel) shall be high strength cold deformed bar (HYSD) of grade Fe-500ĥ- Any minor and major changes are not allowed without written.Ħ- Reduction In Column Size Shall Be Made From Both Faceħ- Concrete. Hare are some basic and important general notes for structure drawing.ġ- Given under this heading shall be uniformly application foe R.C.C.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |